Haas VF-10
Our largest mill, with 120 inches of X travel for long frames and big plates in one setup.
Shop & equipment
The shop behind the work.
33,750 square feet of heavy steel-framed shop on 6.35 acres in Holt, Florida, a short haul from I-10.
Equipment list
On the floor today.
| Machine | Type | Capacity / use |
|---|---|---|
| Haas VF-10 CNC vertical mill | CAT 50 | 120″ × 32″ × 30″ travels |
| Haas VF-4SS CNC vertical mill | CAT 40, Super-Speed | 50″ × 20″ × 25″ travels |
| Hwacheon CNC lathe | CNC turning | Shafts, hubs, bores |
| Lion CU-730 engine lathe (2023) | Manual turning | Long shafts and rolls |
| Lion engine lathe | Manual turning | Shafts, pins, sleeves |
| Hypertherm CNC plasma table | Plate profiling | Parts cut to print |
| American Hole Wizard radial arm drill | Radial drilling | Large plates and weldments |
| Baileigh drill press | Vertical drilling | Production hole work |
| Bridgeport and Hitachi knee mills | Manual milling | One-off work |
| Durmazlar press brake | Forming | Bent plate and angles |
| Baileigh ironworker | Punch, shear, notch | Structural shapes and flat bar |
| DoAll and Marvel bandsaws | Sawing | Bar, pipe and structural |
| Miller and Lincoln welding stations | 13 stations | MIG, stick and flux-core |
| Overhead cranes | 7 total | Two 10-ton, 5-ton, 3-ton, three ½-ton |
| Sandblast room and paint booth | Finishing | Abrasive blast, primer and topcoat |
| Forklift fleet | Material handling | Heavy-capacity Taylor and Hyster trucks |
Lathes
Turning capacity for long shafts, big rolls and bored hubs.
CNC Plasma
In-house plate profiling for gussets, lugs, flanges and chain-race plates.
Facility
Built for heavy steel.
- 33,750 SF shopHeavy steel-framed bays; 39,759 SF total building area
- 6.35 acresYard and laydown for large assemblies and staging
- Drive-in doorsOne 16′ × 20′ and two 14′ × 14′ overhead doors
- Location481 Machinery Circle, Holt, FL 32564